RTS WM300 Especificações descarregar pdf (Página 48)

Chapter 2 Specification of Communication port for CPU module

2 – 34

2.2.5 Factory setting

The factory setting of the Ethernet communication port is as following.

Table 2.21 Factory setting for Ethernet communication port

Item Setup

IP address 192.168.0.1

Subnet mask 255.255.255.0

Default gateway 0.0.0.0

Ethernet communication speed (*) 10M half-duplex

NTP setting Invalid

Time zone GMT+09:00

Task code communication setting

Port 1 Valid

Port 1 Port No. 3004

Port 1 Protocol TCP/IP

Port 2 Valid

Port 2 Port No. 3005

Port 2 Protocol TCP/IP

Port 3 Valid

Port 3 Port No. 3006

Port 3 Protocol TCP/IP

Port 4 Valid

Port 4 Port No. 3007

Port 4 Protocol TCP/IP

Timeout 30

ASR setting

ASR port 0 Invalid

ASR port 1 Invalid

ASR port 2 Invalid

ASR port 3 Invalid

ASR port 4 Invalid

ASR port 5 Invalid

(*) Since the Ethernet communication speed can be changed in Ver.x107 or newer, 5 types of communication speed

(Auto-negotiation, 100M full-duplex/half-duplex, 10M full-duplex/half-duplex) can be set. The communication

speed is set to 10M half-duplex at the shipment. (As for “x” in Ver.x107, it represents EHV-CPU128 when x is 0,

it represents EHV-CPU64 when x is 1, it represents EHV-CPU32 when x is 2, and it represents EHV-CPU16

when x is 3. This version information is stored in the special internal output WRF050.)

Control Editor (Ver.2.00 or newer) or IP address setting tool can change the Ethernet communication speed.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 66 67

Sem comentários

RTS WM300 Especificações Página 48