RTS TR-240 Instruções de Operação descarregar pdf (Página 22)

Beltpack Set-up

Battery Installation

Insure that the On/Off volume control knob is turned off.

Press down and hold down the battery release latch, slide the

battery pack about 1/8 inch back, toward the latch, until it

stops. Then lift battery pack out. Replace batteries as follows:

Figure 18

Battery Installation

4-8

1. Open the battery pack by inserting

finger nail and lifting.

3. Load new batteries following the

polarity as shown in battery case

5. Be sure strap goes under batteries.

4. Start loading at the end of the case where

the strap is attached to the case.

6. Tuck end of strap under door

when placing the battery cover

back on the case.

2. Pull battery strap to remove low

or dead batteries.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 64 65

Sem comentários

RTS TR-240 Instruções de Operação Página 22