RTS XCP-48-RJ45 Especificações descarregar pdf (Página 145)

RJ-11 6 Pin to DB-25M Terminal Printer Cable

Cables

Terminal/Printer Cables,RJ-11 6-pin to DB-25

The wiring diagram for an RJ-11 6-pin to DB-25 terminal/printer cable is shown in Table 1.

Table 1: EIA-232 RJ-11 6-pin to DB-25 terminal/printer cable

From

RJ-11

Signal Direction Signal To DB-25

4 RxD TxD 2

3 TxD

RxD 3

5SG

SG 7

1 RTS

CTS 5

6 CTS

DTR 20

2 GND

GND Shell

* Arrows indicate which direction the signal is flowing

NOTES:

●

This cable utilizes the DTR signal of the terminal/printer for hardware flow control (RTS/CTS).

●

Okidata printers may use SSD (pin 11) instead of DTR (pin 20) on DB25 side in above diagram. If

this is the case, the printer should be set to SSD+.

●

Some Unix operating systems require carrier to be present. If this is the case, the forcedcd

parameter will need to be turned on for this port at the host.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 151 152

Sem comentários

RTS XCP-48-RJ45 Especificações Página 145