RTS XCP-ADAM-MC Manual do Utilizador descarregar pdf (Página 16)

12 Installation DSI-2008

Bosch Security Systems, Inc.

User Manual

F.01U.193.295

Rev. 05

NOTE: If System A or System B will not be used, set the 2W CHAN SEL switch to the off position and attach a

dummy load to the TW XLR connector.

4-Wire Call Signal Connections

NOTE: These connections require the call signal option.

Call Signal Connection for ADAM, ADAM-M, ADAM CS, Zeus and Zeus III

You can use the General Purpose Interface (GPI) connector to interface call signals. The pin-out of the connector is the same

for all of these intercom systems Table 1 on page 13.

ADAM/ADAM-M GPI Connector: XCP-ADAM-MC, J11

ADAM CS GPI Connector: J903

Zeus GPI Connector: J27

Zeus III GPI Connector: GPI

If your intercom system is equipped with a UIO-256 (Universal Input/Output) Frame, you can also use that for connections

(Table 1 on page 13 and Table 2 on page 14).

As an alternative to using the GPI, you can use external components to send and receive call signals as described in “Call

Signal Connections for other 4-wire Communications Systems” on page 15.

Typical GPI connections are shown in Figure 4 on page 12. The example uses GPI outputs #1 and #2 and GPI Input #1. You

may substitute other GPI Input and Outputs.

IMPORTANT: AZedit version 1.06 or higher includes a feature which allows you to invert the action of the GPI

outputs. By default, these output are set to duplicate the action of the RTS FR9528 Relay Frame

accessory. This is the correct setting for use with the DSI 2008. To check the AZedit setting, select

Intercom Configuration in the Options menu. Click on the Options tab, then verify that Configure

onboard GPI outputs in FR9528 mode is selected.

FIGURE 4. Call signal connections for ADAM, ADAM-M, ADAM CS, Zeus and Zeus III Intercom Systems.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Sem comentários

RTS XCP-ADAM-MC Manual do Utilizador Página 16