RTS ICP-2000 Manual do Utilizador descarregar pdf (Página 39)

CHAPTER 4

RVON-8 Card

Serial Port Programming

RVON Serial and Telnet Commands

RVON card programming can be done via direct serial or telnet connection. There are several physical connections to an

RVON board:

• Direct serial through custom debug cable (J20 6-pin bottom front)

The customer debug cable always functions as the general-purpose debug tool.

• Backcard DB-9 J2

The backcard DB-(must be disabled/enabled via a DIP Switch because it can also be used for serial port pass-

through. The backcard DB-9 can be used for a debug terminal when DIP switch 6 is switched to the ON position.

• Backcard RJ-45 J1 (Telnet Only)

Setup

Serial Port: 38.400 baud, No-flow control

Telnet: IP Address, port 23

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 54 55

Sem comentários

RTS ICP-2000 Manual do Utilizador Página 39