RTS ICP-2000 Manual do Utilizador descarregar pdf (Página 44)

All are “set chan #” commands because they are for each audio channel.

Typing, “pintenv”, then pressing Return from an RVON-8 boot code or “sys-printenv” from the MXP Debug System Prompt

may show these commands. The Environment name is listed because this is the label used by the software

IMPORTANT!: If the user is attempting to do a “setenv” to change a parameter from the RVON-8 boot code, the Environment

Name must be used and NOT the “set rvon variable” name.

VARIABLE ENVIRONMENT NAME DEFAULT

VA L U E

DESCRIPTION

dest_ip RVON_DEST_IP_# X.X.X.X Destination IP Address for this particular

RVON_CH

dest_type RVON_DEST_TYPE_3 X Destination Type Y= 0 (rvon-8), 1 (rvon-1), 2

(rvon-I/O)

dest_chan RVON_DEST_CHAN_# X Destination Channel - what port of far end (0-7)

chan_codec RVON_CHAN_CODEC_# X Profile to use (previous coding table)

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 54 55

Sem comentários

RTS ICP-2000 Manual do Utilizador Página 44