RTS RVON-I/O Manual do Utilizador descarregar pdf (Página 27)

8. At the prompt, type d/jointfilesconvert/320764/bgcmd to access the debug command screens.

9. Press Enter.

An MXP prompt appears.

10. At the MXP prompt, type set rvon ip_addr 10.3.210.12 (this IP Address is for example purposes only).

11. Press Enter.

The IP Address is set for the RVON-I/O.

12. Set the Netmask.

13. At the MXP prompt, type Activate.

RVON-I/O will reset itself to the new IP Address. The current telnet session becomes invalid.

Configure the IP Address Using the Serial Debug Port

NOTE: In order to use the Serial Debug Port to set the IP Address for your RVON-I/O, you must know the intended IP

Address. Also, you must make sure DIP switch 2 is not enabled (CLOSED).

The following instructions will show you how to access the Serial Debug Port screens and show you how to configure the IP

Address for the RVON-I/O

To configure the IP Address for the RVON-I/O, do the following:

1. Connect the PC’s COM port to the RVON-I/O’s serial connector.

2. Run a HyperTerminal program.

The window provided Hyper Terminal is located at Start Programs>Accessories>Communications >HyperTerminal.

3. At the prompt, type d/jointfilesconvert/320764/bgcmd.

Figure 5.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 59 60

Sem comentários

RTS RVON-I/O Manual do Utilizador Página 27