RTS XCP-48-RJ45 Manual do Utilizador descarregar pdf (Página 8)

DIP Switches

NOTE: You must remove the card from the frame in order to change any DIP switch settings.

FIGURE 1. Default DIP switch settings on the AIO-16 card (SB01).

DIP Switch 1 Controls the initial load (or reload) of the firmware.

OFF (open) Normal operation

ON (closed) Boot into debug mode.

Description When the switch is in the on position, the AIO-16 card skips the firmware programmed in flash.

When the switch is in the off position, it runs the firmware from flash.

DIP Switches 2-7

Keep in the off position.

DIP Switch 8 Debug Only

CAUTION: DIP Switch 8 should always be left in the off position. It is reserved for debugging

and can have unintended consequences.

12345678

SB01

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 71 72

Sem comentários

RTS XCP-48-RJ45 Manual do Utilizador Página 8