RTS DV-3400 Informações Técnicas descarregar pdf (Página 140)

100

101

Switch Memory and Configuration

Multiple Configuration Files on 5300xl and 4200vl Switches

You can use the following command to change the current policy so that the

switch automatically boots using a different startup-config file.

Syntax: startup-default [ primary | secondary ] config < filename >

Specifies a boot configuration policy option:

[ primary | secondary ] config < filename >: Designates the

startup-config file to use in a reboot with the software

version stored in a specific flash location. Use this option

to change the reboot policy for either primary or

secondary flash, or both.

config < filename >: Designates the startup-config file to use

for all reboots, regardless of the flash version used. Use

this option when you want to automatically use the same

startup-config file for all reboots, regardless of the flash

source used.

Note: To override the current reboot configuration policy for

a single reboot instance, use the boot system flash command

with the options described under “Overriding the Default

Reboot Configuration Policy” on page 6-31.

For example, suppose:

■ Software release E.09.xx is stored in primary flash and a later software

release is stored in secondary flash.

■ The system operator is using memory slot 1 for a reliable, minimal

configuration (named minconfig) for the software version in the primary

flash, and slot 2 for a modified startup-config file (named newconfig) that

includes untested changes for improved network operation with the

software version in secondary flash.

The operator wants to ensure that in case of a need to reboot by pressing the

Reset button, or if a power failure occurs, the switch will automatically reboot

with the minimal startup-config file in memory slot 1. Since a reboot due to

pressing the Reset button or to a power cycle always uses the software version

in primary flash, the operator needs to configure the switch to always boot

from primary flash with the startup-config file named minconfig (in memory

slot 1). Also, whenever the switch boots from secondary flash, the operator

also wants the startup-config named newconfig to be used. The following two

commands configure the desired behavior.

ProCurve(config)# startup-default pri config minconfig

ProCurve(config) # startup-default sec config newconfig.

6-30

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 579 580

Comentários a estes Manuais

Sem comentários

RTS DV-3400 Informações Técnicas Página 140

Comentários a estes Manuais