RTS DV-3400 Informações Técnicas descarregar pdf (Página 195)

100

101

Time Protocols

SNTP: Viewing, Selecting, and Configuring

In this example, the Poll Interval and the Protocol

Version appear at their default settings.

Note: Protocol Version appears only when there is an

IP address configured for an SNTP server.

Figure 9-8. Example of Configuring SNTP for Unicast Operation

If the SNTP server you specify uses SNTP version 4 or later, use the sntp server

command to specify the correct version number. For example, suppose you

learned that SNTP version 4 was in use on the server you specified above (IP

address 10.28.227.141). You would use the following commands to delete the

server IP address and then re-enter it with the correct version number for that

server:

Deletes unicast SNTP server entry.

Re-enters the unicast server with a non-

default protocol version.

show sntp displays the result.

Figure 9-9. Example of Specifying the SNTP Protocol Version Number

Changing the SNTP Poll Interval.

Syntax:

sntp poll-interval < 30..720 >

Specifies how long the switch waits between time polling

intervals. The default is 720 seconds and the range is 30 to

720 seconds. (This parameter is separate from the poll inter-

val parameter used for Timep operation.)

For example, to change the poll interval to 300 seconds:

ProCurve(config)# sntp poll-interval 300

9-13

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 579 580

Comentários a estes Manuais

Sem comentários

RTS DV-3400 Informações Técnicas Página 195

Comentários a estes Manuais