RTS DV-3400 Informações Técnicas descarregar pdf (Página 186)

100

101

Time Protocols

Selecting a Time Synchronization Protocol or Turning Off Time Protocol Operation

3. Configure the remaining parameters for the time protocol you selected.

The switch retains the parameter settings for both time protocols even if

you change from one protocol to the other. Thus, if you select a time

protocol, the switch uses the parameters you last configured for the

selected protocol.

Note that simply selecting a time synchronization protocol does not enable

that protocol on the switch unless you also enable the protocol itself (step 2,

above). For example, in the factory-default configuration, TimeP is the

selected time synchronization method. However, because TimeP is disabled

in the factory-default configuration, no time synchronization protocol is

running.

Disabling Time Synchronization

You can use either of the following methods to disable time synchronization

without changing the Timep or SNTP configuration:

■ In the System Information screen of the Menu interface, set the Time

Synch Method

parameter to None, then press [Enter], then [S] (for Save).

■ In the Global config level of the CLI, execute no timesync.

9-4

1 2 ... 181 182 183 184 185 186 187 188 189 190 191 ... 579 580

Comentários a estes Manuais

Sem comentários

RTS DV-3400 Informações Técnicas Página 186

Comentários a estes Manuais