RTS DV-3400 Informações Técnicas descarregar pdf (Página 266)

100

101

Access Controller xl Module for the Series 5300xl Switches

Access Controller xl Module Overview

The Access Controller xl Module has no external ports, as shown in Figure

12-12-1. The module uses ports on the 5300xl switch through two internal

ports, the uplink port and the downlink port. Clients, typically connecting

through an access point, connect to 5300xl ports defined as downlink client

ports. The internal uplink port passes network traffic through other 5300xl

ports, which are external uplink network ports. VLANs are used to direct

traffic to and from the ACM.

For an explanation of the module’s features and LEDs, see the ProCurve xl

Modules Installation Guide.

Note Uplink and downlink port names depend on the switch slot where the module

is installed. When the module is in switch slot A, ‘N’ is ‘A’ in Figure 12-12-1.

The uplink port for the module is AUP; the downlink port is ADP.

The following steps are required to add an ACM to your network:

1. Install an Access Control Server 740wl or Integrated Access Manager

760wl in the network, or identify an existing 740wl or 760wl to be used

with the ACM.

2. Having identified the Access Control Server 740wl or Integrated Access

Manager 760wl to be used with the ACM, note its IP address. To operate,

the ACM must establish secure communications with the Access Control

Server or Integrated Access Manager.

The shared secret configured on the 740wl/760wl’s is also needed. If you

are already using a 760wl, you may not have configured a shared secret.

See “Editing the Access Control Server Configuration” in the ProCurve

Secure Access 700wl Series Management and Configuration Guide,

available on the Documentation CD-ROM shipped with your module or

from the ProCurve Networking Web site at

www.procurve.com

(Click on Technical support, then Product manuals (all)).

3. Install the ACM in a slot on the 5300xl switch. Once the Module Ready

LED is on, the ACM requires an IP address. By default, the ACM uses

DHCP. The IP address also can be set manually. The uplink port must be

an untagged member of a VLAN that can communicate with the 740wl or

760wl. The ACM establishes communication with the 740wl/760wl, using

the IP address and the shared secret from step 2 above. See the ProCurve

xl Modules Installation Guide for details.

12-6

1 2 ... 261 262 263 264 265 266 267 268 269 270 271 ... 579 580

Comentários a estes Manuais

Sem comentários

RTS DV-3400 Informações Técnicas Página 266

Comentários a estes Manuais