RTS DV-3400 Informações Técnicas descarregar pdf (Página 460)

100

101

File Transfers

Copying Diagnostic Data to a Remote Host, PC, or UNIX Workstation

Copying Event Log Output to a Destination Device

Syntax: copy event-log tftp < ip-address > < filepath_filename >

copy event-log xmodem

These commands use TFTP or Xmodem to copy the Event Log

content to a PC or UNIX workstation on the network.

For example, to copy the event log to a PC connected to the switch:

At this point, press

[Enter] and start the

Xmodem command

sequence in your

terminal emulator.

Figure A-11. Example of Sending Event Log Content to a File on an Attached PC

Copying Crash Data Content to a Destination Device

This command uses TFTP or Xmodem to copy the Crash Data content to a PC

or UNIX workstation on the network. You can copy individual slot information

or the master switch information. If you do not specify either, the command

defaults to the master data.

Syntax: copy crash-data [<slot-id | master>] xmodem

copy crash-data [<slot-id | master>] tftp <ip-address> <filename>

where: slot-id = a - h, and retrieves the crash log or crash data from

the processor on the module in the specified slot.

master Retrieves crash log or crash data from the switch’s

chassis processor.

These commands use TFTP or Xmodem to copy the Event Log

content to a PC or UNIX workstation on the network.

For example, to copy the switch’s crash data to a file in a PC:

A-30

1 2 ... 455 456 457 458 459 460 461 462 463 464 465 ... 579 580

Comentários a estes Manuais

Sem comentários

RTS DV-3400 Informações Técnicas Página 460

Comentários a estes Manuais