RTS DV-3400 Informações Técnicas descarregar pdf (Página 448)

100

101

File Transfers

Downloading Switch Software

c. In the Protocol field, select Xmodem.

d. Click on the [Send] button.

The download can take several minutes, depending on the baud rate used

in the transfer.

3. When the download finishes, you must reboot the switch to implement

the newly downloaded software. To do so, use one of the following

commands:

Syntax:

boot system flash <primary | secondary>

Reboots from the selected flash.

Syntax:

reload

Reboots from the flash image currently in use.

(For more on these commands, see “Rebooting the Switch” on page 6-18.)

4. To confirm that the software downloaded correctly:

ProCurve> show system

Check the Firmware revision line. It should show the software version that

you downloaded in the preceding steps.

If you need information on primary/secondary flash memory and the boot

commands, see “Using Primary and Secondary Flash Image Options” on page

6-13.

Switch-to-Switch Download

You can use TFTP to transfer a software image between two switches of the

same series. (For example, all of the Series 5300xl switches use software with

the “E” identifier, such as E.08.40.swi, all of the Series 3400cl and Series 6400cl

switches use software with the “M” identifier, such as M.08.01, and all of the

Series 4200vl switches use the “L” identifier, such as L.10.xx.) The menu

interface enables you to transfer primary-to-primary or secondary-to-primary.

The CLI enables all combinations of flash location options.

Menu: Switch-to-Switch Download to Primary Flash

Using the menu interface, you can download a switch software file from either

the primary or secondary flash of one switch to the primary flash of another

switch of the same series.

A-18

1 2 ... 443 444 445 446 447 448 449 450 451 452 453 ... 579 580

Comentários a estes Manuais

Sem comentários

RTS DV-3400 Informações Técnicas Página 448

Comentários a estes Manuais