RTS DV-3400 Informações Técnicas descarregar pdf (Página 172)

100

101

Configuring IP Addressing

IP Configuration

Note The default IP address setting for the DEFAULT_VLAN is DHCP/Bootp. On

additional VLANs you create, the default IP address setting is Disabled.

Syntax: [ no ] vlan < vlan-id > ip address <ip-address/mask-length>

[ no ] vlan < vlan-id > ip address < ip-address > < mask-bits >

vlan < vlan-id > ip address dhcp-bootp

This example configures IP addressing on the default VLAN with the subnet

mask specified in mask bits.

ProCurve

(config)# vlan 1 ip address 10.28.227.103 255.255.255.0

This example configures the same IP addressing as the preceding example,

but specifies the subnet mask by mask length.

ProCurve(config)# vlan 1 ip address 10.28.227.103/24

This example deletes an IP address configured in VLAN 1.

ProCurve (config) no vlan 1 ip address 10.28.227.103/24

Configure Multiple IP Addresses on a VLAN (Multinetting). You can

configure up to eight IP addresses for the same VLAN. That is, the switch

enables you to assign up to eight networks to a VLAN.

■ Each IP address on a VLAN must be for a separate subnet.

■ The switch allows up to 512 secondary subnet address assignments to

VLANs.

Syntax: [ no ] vlan < vlan-id > ip address < ip-address/mask-length >

[ no ] vlan < vlan-id > ip address < ip-address > < mask-bits >

For example, if you wanted to multinet VLAN_20 (VID = 20) with the IP

addresses shown below, you would perform steps similar to the following.

(For this example, assume that the first IP address is already configured.)

IP Address VID IP Address Subnet Mask

1st address 20 10.25.33.101 255.255.240.0

2nd address 20 10.26.33.101 255.255.240.0

3rd address 20 10.27.33.101 255.255.240.0

8-8

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 579 580

Comentários a estes Manuais

Sem comentários

RTS DV-3400 Informações Técnicas Página 172

Comentários a estes Manuais